If the existing irrigation system needs another zone or an additional master valve for irrigation control, or if there is a bad splice, a cut wire, or a low-pressure problem, then Add-A-Zone has your solution.

There is no need to disrupt the landscape to lay new wiring. There is no need to re-design the complete irrigation system because Add-A-Zone is the easiest and most convenient unit that solves these problems and adds more control.

Add-A-Zone does more than adding a zone

Add-A-Zone Timing and Control

Add-A-Zone behaves as if the valves are fully independent, unlike other switching devices which means there’s no need for “watering every other cycle”. Both of the solenoid valves that connect through the Add-A-Zone can be independently timed and controlled for automatic and manual operations.

Power from two zones on a controller can be transmitted to valves in the field through only one pair of field wires. The unit is installed at an open station on the controller and allows two valves to have separate watering schedules and programs while the signal is sent through one wire.

The Added Zone can be fully controlled

Irrigation Problems Solved

When you find any of the following situations, they are easily solved with Add-A-Zone: no time or budget to adding wiring, working around a bad splice or cut wire, solving a low pressure problem, need an added master valve.

Add-A-Zone installs in minutes and provides you with much flexibility and maximum control. It is inexpensive to install and very simple to use.

Purchase Add-A-Zone

You can purchase the Add-A-Zone directly from our Customer Portal, or you can call or visit a Wolf Creek branch near you.

Read more articles on irrigation products here.

Facebooktwitterlinkedinyoutube

Leave a Reply

Your email address will not be published. Required fields are marked *